Berghaus Customer Service
At Berghaus, we believe that it's really important for your clothing to fit well. All of our products are designed to perform, and because we make products for a wide range of activities not every product will fit in quite the same way. Our size chart measurements are set out here; these refer to body size rather than the products, so you can work out what product size you will be.
Additional information
* The waist size for shorts is the same as for trousers
* Charts refer to body measurements and not to the products
Additional information
The waist size for shorts is the same as for trousers
Charts refer to body measurements and not to the products
METRIC
IMPERIAL
Measuring tips
Take your actual body measurements as they are more accurate than measuring over your clothes or shoes.
Collar: measure around the base of the neck where the collar sits.
Chest: measure the chest at the fullest part, placing the tape close up under the arms.
Waist: measure the natural waistline.
Inside Leg: measure from the crotch to where your trouser is normally worn on the shoe.
Jacket Length: measure from the centre back of your neck to your hemline. Then length measurement will vary depending on the style.
Feet: Use a ruler or tape measure to measure your foot (from the heel to the tip of your longest toe) Be sure to measure both feet. Many people have feet of different sizes. Fit to the larger of the two.
At Berghaus we know that getting the right fit of a rucksack is really important.
To help us tailor the fit of our backsystems our range is built around three types of fit system.
Each of these three systems have a variety of benefits that are relevant to the end uses that the rucksack is used for.
CYCLOPS & FUSION 3 BACKLENGTH MEASUREMENTS (FUSION 3 IS ONLY AVAILABLE IN SIZE 3 & 4)
Additional information
Our sized backsystem include the world renowned Cyclops system and the newer Fusion 3 system. Both systems are available in a variety of sizes that give a more tailored fit for the individual, but without the addition of the mechanics required to build an adjustable system.
This simple and light approach makes the sized systems ideal for more rugged environments and longer duration trips where resupply is difficult and where you are likely to be carrying heavy loads perhaps in excess of 20kg.
Additional information
Our adjustable systems are based around the principle that one size can fit all. The backlength of the adjustable system can be varied to achieve a great fit on almost all sizes of people.
Adjustability is built into the Bioflex, Bioflex Light, Biofit, A-Trek & the larger Freeflow packs. These multiple systems allow us flexibility in designing rucksacks for different end uses and for a wide variety of loads.
Back length for Adjustable Systems (Bioflex, Bioflex Light, Biofit, A-Trek & Freeflow)
Back length is measured from the top of the hip bone to the apex of the shoulder (following the curvature of the body).
* Our rucksacks with a one size system are manufactured with a backlength of 45cm (unisex) or 41cm (womens). This allows the packs to fit the maximum number of people.
Additional information
The gaiter is engineered to be a secure and tight fit on mountaineering boots,
therefore you may prefer to choose a size larger than your normal boot size.
Hand length
Measure from the top of your middle finger to the wrist (fig 1)
Hand width
Measure from the base of your thumb knuckle to the outside of your hand (fig 2)
Hand circumference
Measure from the total circumference of your hand below your finger knuckles (fig 3)